Place of Origin:
CQC CE CB TUV ROHSE
YB-F2 Ehanced Single Phase Filter 115V/250V Two-stage EMI/RFI Filter For Charging Pile
We have the relevant product's certificates,multiple installation options are available, product can be customized working with the top research LABS to provide free EMC diagnostic test
|YB-F2 Single phase filter
|Nominal Center Frequency
|25 / 085 / 21
|Line to Line
|Line to Ground
|2250VDC or 2000VAC
|Maximum Leakage Current
|250VAC/60HZ 1.4mA Max. 440VAC/60HZ 2.5mA Max
|3~15 weekday for Low Pass EMI Filter
-- Protection against interference of voltage
-- Industry-standard EMC solution for three-phase PDS filtering
-- Customized products according to customer's requirements.
-- Building automation
-- Elevator equipment
-- Power supplies
-- Manipulator equipment
-- Industrial automation equipment
-- New energy equipment
Filter Selection Table:
|Rated Currents (A)
*Q: Fast-on 6.35x0.8mm S: Screw lug T: Terminal block
YB35F2-30A-S EMI/RFI Filter Picture:
Insertion loss table(In 50ohm system according IEC/CISPR No.17)
---Shipping terms: DHL, UPS, FedEx, TNT, EMS
---Port is Shenzhen or as requests.
1. What is an EMI power filter?
A: EMI power filters are electromagnetic interference mitigating components used to reduce the disturbances in a power line. They are commonly made of inductors and capacitors and are collectively called passive EMI power filters.
2. Why do we need EMI filter?
A: Electromagnetic compatibility (EMC) is an important indicator to measure the quality of electronic products, and it has increasingly become the key in the design of electronic products. In the design process of the power system, the introduction of electromagnetic compatibility design can improve the overall anti-interference ability of the power system, extend the service life of the system, and ensure the safety of use. Therefore, the electromagnetic interference filter is a device that provides good electromagnetic compatibility.
3. Where should I place my EMI filter?
A: A power line or mains EMI filter is placed at the power entry point of the equipment that it is being installed into to prevent noise from exiting or entering the equipment. Essentially, an EMI filter is made up of two basic types of components–capacitors and inductors.
4. How does EMI filter works?
A: EMI, or Electro-Magnetic Interference, is defined as unwanted electrical signals and can be in the form of conducted or radiated emissions. The capacitors provide a low impedance path to divert the high frequency noise away from the input of the filter, either back into the power supply, or into the ground connection.
Send your inquiry directly to us